Weighing system | Automatic rate control


Profis weighing technology – Who weighs wins!

No calibration: enter the spread rate and drive off! There is nothing simpler. The weighing system provides controlled convenience and more safety enabling an on-line determination of the different spreading material properties with two 200 Hz weigh cells – with high measuring accuracy. It automatically compares the actually applied rate with the pre-determined rate. Deviations in the flow characteristics, for example when spreading blended mineral fertilisers, are detected and the spreader is re-adjusted automatically via the electric metering shutter slides. In addition, for field-related nutrient application, for example, the applied rate is precisely documented. For a well-balanced nutrient supply, the application rate can be changed via the ISOBUS terminal at the touch of a button. (1) weighing frame (2) horizontally aligned tie rods (3) weigh cells

More information + Less information -

Tilt sensor for heavily undulating terrain

With the Profis, possible changes in the centre of gravity are taken into account during the measuring procedure whilst on the move via the tilt sensing technology: the two-dimensional tilt sensor which records the angle, both to the front and the rear and to the left and right hand side, corrects the measuring inaccuracies which might arise when driving up and down hill or that might occur when driving on sloping ground.

More information + Less information -

FlowCheck – for monitoring the spreader aperture

With FlowCheck, AMAZONE offers a system that continually monitors the shutter apertures against blockage or should they run empty. Whereas FlowCheck ensures that the application rate is the same on both sides or, in case of any deviation, informs the driver of a potential error. The overall application rate is monitored and regulated via the weighing system. In addition, the driver is always informed via the weigh-cells of the actual fill level in the hopper.

More information + Less information -

WindControl - Calm conditions at the touch of a button

The effect of the wind on the spread pattern can be permanently monitored and automatically compensated for by WindControl. A high-frequency wind sensor mounted on the machine records both the wind speed and the wind direction and transmits this information to the job computer.

Image film AMAZONE 1883

We need your consent

This content is provided by an external server. By activating the content, personal data may be accessed and Cookies may be utilised.